I Cannabinoidi Sintetici (CS) occupano uno spazio rilevante nel contesto emergente delle Nuove Sostanze Psicoattive (NSP). Ad oggi, per la determinazione dei CS ci si avvale dell’ausilio di strumentazioni all’avanguardia, come tecniche di Cromatografia Liquida o Gassosa, accoppiate alla Spettrometria di Massa (LC/GC – MS). Nonostante questo approccio analitico abbia avuto grande successo nella determinazione di CS, sia nelle preparazioni clandestine che li contengono, che nei fluidi biologici di consumatori, si tratta comunque di strumentazioni molto costose e difficilmente fruibili per analisi di screening nei laboratori di routine. Lo scopo di questo progetto è stato lo sviluppo di un metodo analitico, basato sulla separazione cromatografica (in HPLC) associata ad una detection in UV e fluorescenza, per la determinazione di CS nelle miscele erbacee, ovvero nei cosiddetti “Herbal blends”. Per la parte sperimentale è stato impiegato un sistema HPLC-UV-FL così composto: Pompa HPLC LC-10AD (Shimadzu, Tokio); detector spettrofotometrico 875-UV Intelligent (Jasco, Japan); Fluorimetro RF10XAL (Shimadzu, Tokio)]. Nella fase separativa è stata utilizzata una colonna C18 a fase inversa [Discovery, 150 mm x 4.6 mm, 3 μm, (Supelco, PA, USA)]. Il modulo di comunicazione utilizzato è stato CBM-20A Prominence (Shimadzu) e il programma sul PC “LabSolution” (2008-2010, Shimadzu Corporation). Il metodo analitico si basa su una separazione isocratica e una fase mobile composta da METOH/H2O (87,20/12,80, v/v); il flusso di lavoro è stato impostato a 1 ml/min, la pressione si è mantenuta intorno ai 200 bar. La migliore lunghezza d’onda di assorbimento, ottenuta per ottimizzazione delle condizioni sperimentali è 229 nm, mentre per la maggior parte degli composti, si è ottenuto il migliore segnale in fluorescenza alle seguenti lunghezze d’onda: 350 nm (eccitazione) e 425 nm (emissione). La preparazione del campione di miscela erbacea si basa su una semplice procedura estrattiva (≈20 mg di campione sono stati incubati o.n. in 2 ml di metanolo, a temperatura ambiente). Nelle condizioni sperimentali descritte sono stati separati nove CS entro 10 minuti e col seguente ordine di eluizione: JWH-200, AM-694, JWH-015, JWH -250, JWH-073, JWH-018, JWH-081, JWH-019, JWH-210. Le prove di linearità sono state eseguite considerando il range di concentrazione 1-10 µM. I valori ottenuti per la sensibilità vanno da 5.94 ng/ml (JWH-081) a 21.28 ng/ml (JWH-073). Il metodo è stato applicato all’analisi di alcune miscele erbacee sequestrate in Smart Shops.

Synthetic cannabinoids (SC) represent a very important side of the emerging and worrying phenomenon of the New Psychoactive substances (NPS). Currently, the determination of SC is based on the use of LC/GC – MS techniques. Although this analytical approach have been successfully applied to the determination of SC in both clandestine preparations and biological fluids, it is expensive and usually not suitable for the screening analysis in routine laboratories. Aim of this work was the development of a method based on a HPLC separation associated with a UV and FL detection, for the determination of SC in herbal mixtures. The experiments were performed using a HPLC-UV-FL system [LC-10AD HPLC Pump (Shimadzu, Tokio); Jasco 875-UV Intelligent Spectrophotometric detector (Jasco, Japan); RF10XAL Fluorescence detector (Shimadzu, Tokio)]. A reversed phase C18 column [Discovery, 150 mm x 4.6 mm, 3 μm, (Supelco, PA, USA)] was employed. The Communication Bus Module was a CBM-20A Prominence (Shimadzu) and the program on PC was “LabSolution” (2008-2010, Shimadzu Corporation). The separation was isocratic with a mobile phase composed by MEOH/H2O (87,20/12,80, v/v); the flow was set at 1 ml/min; the pressure was ≈ 200 bar. After optimization the best UV absorption scored at 229 nm, while, for the majority of the compounds, the best fluorescence signal was obtained at excitation wavelength = 350 nm and emission wavelength = 425 nm. The sample preparation of herbal mixtures was based on a simple extraction procedure (≈20 mg of sample incubated o.n. in 2 ml of MEOH at room temperature). Under the described conditions, nine SC were separated within 10 minutes with the following elution sequence: JWH-200, AM-694, JWH-015, JWH -250, JWH-073, JWH-018, JWH-081, JWH-019, JWH-210. Linearity was tested in the 1-10 µM concentration range. The analytical sensitivity ranged from 5.94 ng/ml (JWH-081) to 21.28 ng/ml (JWH-073). The method was successfully applied to the analysis of herbal mixtures seized at Smart Shops.

Synthetic Cannabinoids: general aspects and screening analysis by HPLC-UV-Fl technique

Trapani, Elisa
2014-01-01

Abstract

Synthetic cannabinoids (SC) represent a very important side of the emerging and worrying phenomenon of the New Psychoactive substances (NPS). Currently, the determination of SC is based on the use of LC/GC – MS techniques. Although this analytical approach have been successfully applied to the determination of SC in both clandestine preparations and biological fluids, it is expensive and usually not suitable for the screening analysis in routine laboratories. Aim of this work was the development of a method based on a HPLC separation associated with a UV and FL detection, for the determination of SC in herbal mixtures. The experiments were performed using a HPLC-UV-FL system [LC-10AD HPLC Pump (Shimadzu, Tokio); Jasco 875-UV Intelligent Spectrophotometric detector (Jasco, Japan); RF10XAL Fluorescence detector (Shimadzu, Tokio)]. A reversed phase C18 column [Discovery, 150 mm x 4.6 mm, 3 μm, (Supelco, PA, USA)] was employed. The Communication Bus Module was a CBM-20A Prominence (Shimadzu) and the program on PC was “LabSolution” (2008-2010, Shimadzu Corporation). The separation was isocratic with a mobile phase composed by MEOH/H2O (87,20/12,80, v/v); the flow was set at 1 ml/min; the pressure was ≈ 200 bar. After optimization the best UV absorption scored at 229 nm, while, for the majority of the compounds, the best fluorescence signal was obtained at excitation wavelength = 350 nm and emission wavelength = 425 nm. The sample preparation of herbal mixtures was based on a simple extraction procedure (≈20 mg of sample incubated o.n. in 2 ml of MEOH at room temperature). Under the described conditions, nine SC were separated within 10 minutes with the following elution sequence: JWH-200, AM-694, JWH-015, JWH -250, JWH-073, JWH-018, JWH-081, JWH-019, JWH-210. Linearity was tested in the 1-10 µM concentration range. The analytical sensitivity ranged from 5.94 ng/ml (JWH-081) to 21.28 ng/ml (JWH-073). The method was successfully applied to the analysis of herbal mixtures seized at Smart Shops.
2014
Synthetic cannabinoids
I Cannabinoidi Sintetici (CS) occupano uno spazio rilevante nel contesto emergente delle Nuove Sostanze Psicoattive (NSP). Ad oggi, per la determinazione dei CS ci si avvale dell’ausilio di strumentazioni all’avanguardia, come tecniche di Cromatografia Liquida o Gassosa, accoppiate alla Spettrometria di Massa (LC/GC – MS). Nonostante questo approccio analitico abbia avuto grande successo nella determinazione di CS, sia nelle preparazioni clandestine che li contengono, che nei fluidi biologici di consumatori, si tratta comunque di strumentazioni molto costose e difficilmente fruibili per analisi di screening nei laboratori di routine. Lo scopo di questo progetto è stato lo sviluppo di un metodo analitico, basato sulla separazione cromatografica (in HPLC) associata ad una detection in UV e fluorescenza, per la determinazione di CS nelle miscele erbacee, ovvero nei cosiddetti “Herbal blends”. Per la parte sperimentale è stato impiegato un sistema HPLC-UV-FL così composto: Pompa HPLC LC-10AD (Shimadzu, Tokio); detector spettrofotometrico 875-UV Intelligent (Jasco, Japan); Fluorimetro RF10XAL (Shimadzu, Tokio)]. Nella fase separativa è stata utilizzata una colonna C18 a fase inversa [Discovery, 150 mm x 4.6 mm, 3 μm, (Supelco, PA, USA)]. Il modulo di comunicazione utilizzato è stato CBM-20A Prominence (Shimadzu) e il programma sul PC “LabSolution” (2008-2010, Shimadzu Corporation). Il metodo analitico si basa su una separazione isocratica e una fase mobile composta da METOH/H2O (87,20/12,80, v/v); il flusso di lavoro è stato impostato a 1 ml/min, la pressione si è mantenuta intorno ai 200 bar. La migliore lunghezza d’onda di assorbimento, ottenuta per ottimizzazione delle condizioni sperimentali è 229 nm, mentre per la maggior parte degli composti, si è ottenuto il migliore segnale in fluorescenza alle seguenti lunghezze d’onda: 350 nm (eccitazione) e 425 nm (emissione). La preparazione del campione di miscela erbacea si basa su una semplice procedura estrattiva (≈20 mg di campione sono stati incubati o.n. in 2 ml di metanolo, a temperatura ambiente). Nelle condizioni sperimentali descritte sono stati separati nove CS entro 10 minuti e col seguente ordine di eluizione: JWH-200, AM-694, JWH-015, JWH -250, JWH-073, JWH-018, JWH-081, JWH-019, JWH-210. Le prove di linearità sono state eseguite considerando il range di concentrazione 1-10 µM. I valori ottenuti per la sensibilità vanno da 5.94 ng/ml (JWH-081) a 21.28 ng/ml (JWH-073). Il metodo è stato applicato all’analisi di alcune miscele erbacee sequestrate in Smart Shops.
File in questo prodotto:
File Dimensione Formato  
PhD thesis ELISA TRAPANI.pdf

non disponibili

Tipologia: Tesi di dottorato
Licenza: Accesso ristretto
Dimensione 1.02 MB
Formato Adobe PDF
1.02 MB Adobe PDF   Visualizza/Apri   Richiedi una copia

I documenti in IRIS sono protetti da copyright e tutti i diritti sono riservati, salvo diversa indicazione.

Utilizza questo identificativo per citare o creare un link a questo documento: https://hdl.handle.net/11562/696360
Citazioni
  • ???jsp.display-item.citation.pmc??? ND
  • Scopus ND
  • ???jsp.display-item.citation.isi??? ND
social impact